Trbo

I talked to a mechanic and he said that it is the engine harness that needs to be replaced. Also, the injectors need to be checked over.

That hesitation/surge problem is annoying. I'm guessing that it isn't a major problem, though (less than $500 fix). Anyway, I'll hopefully know by tomorrow, and if not then, by the end of the week.

Hells yes man, get those pics up!

I actually didn't finish completely yesterday. I have one more line to install and even after that is complete I do not see my Z hitting the streets any time soon. After repainting all of the suspension arms and what not, I am not into having that all covered in salt! Damn winter .... I picked up Motul 600 for the fluids. Should I get it out though, I will let you know what I think.

Its odd that you asked about bleeding the brakes ... I just did that yesterday when I replaced the old rubber lines with SS lines. I had the links on standby lol. Good luck man, it is pretty simple. What fluid are you using?

800hp=1 unicorn power is amazing =]

If they aren't seated properly I could see that. Give it some time to see if the noise fades. If not, def check out your sway bar bushings.

Did you make sure to install them the way CPARK instructs ie was the top of the loop part of the heim joint leaning towards the engine with the car in the air. I could see that if not installed correctly, the excess stress on the Trod could make noise.

Your symptoms could be the Trod or the sway bar because both of those components are moving under acceleration

When does it creak?

If in corners then I would think that the Sway Bar Bushing is making the noise. Spray some silicone lube on them to stop the noise. Also, what tension rods did you go with?

Didn't you install ES bushings?