rockchucker

Thanks DOOOOOOOD!

Happy birthday!

sh!t, thought i was PMing you - it said conversation between you and me. sorry man...

oh one more thing, i've heard of a company STS and their rear mount turbo kits. do they make (or could they make) something that'd work for the Z and would that (with low boost setting due to higher compression of NA engine) be worthwhile checking out?

hey man, quick question for you. i was, like another guy who just posted in NWZC section here, thinking about a TT swap (in my vert). i've heard around that you come highly recommended, so i thought i'd reach out to see about it...

would you do a NA-TT conversion with my motor, or would i need a TT motor? do you have motors and all the goodies one would need to do a swap, or would i hafta source them out? how much do you ballpark charge for the service normally (either labour, or labour/parts if applicable)?

would you even recommend the swap or do you think i could achieve decent (and more reliable) power with a few more mods to my car as it sits. i have intake, exhaust, ECU, and a not-installed-yet pulley.

thanks for your time and advice...

Please do not post questions in this area. PM me or start a thread with the issue at hand then send me a link to the thread.

Can you change the title of this thread? I would like to remove the "help"....

http://www.300zxclub.com/showthread.php?t=217776

I figured out how to log RPM and TPS and I will take some pics and post an explanation trying to remedy this thread flame-out becuase I posted in the wrong section.

Thanks.
Kevin.

Hello, I was reading your how-to on the diff and sub ES bushing swap and was wondering if you had a hard time putting your diff into the rear bushings? I have my diff inserted into the rear bushing but I cannot get the front bushing through bolt to line up with the hole. I'm about 1/2 inch off. I have straps pulling the diff back now but still need 1/4 inch to get the diff support to line up.
And also, I removed my subframe bushings and did like you did on the bottom collar( sawsall) a groove in the bottom lip of that very most inner cup. Are yours holding up well? I'm guessing its not a big deal. Just wish I would have come across your how-to sooner! Thank you in advance!

Mutha chucker! Heya bro, I'm gettin back into the scene. > Woo WOooo

Cory,